Ken Welch

Author Archives: Ken Welch

Ken was the cofounder and CEO at SIMSOLID corporation. He has over 30 years experience in the CAE industry in a variety of technical, sales and executive roles at companies including PDA Engineering, Rasna, Moldflow and MSC Software. Ken holds a B.S. and M.S. in civil engineering from the University of California, Davis.

Altair SimSolid, a revolution in design simulation

Everyone that tries Altair SimSolid for the first time invariably does it using the same methods learned from years of doing classical FEA.  They isolate a small group of parts, simplify the geometry, guess at some boundary loads/constraints and run … Read More

New Altair SimSolid safety factor plots

Safety factors are used to characterize zones of possible material failure and are based on material specific failure criteria. Now available in the latest release of the Altair SimSolid Standard and Power editions, safety factors contour plots can be displayed for … Read More

New Altair SimSolid safety factor plots

Safety factors are used to characterize zones of possible material failure and are based on material specific failure criteria. Now available in the latest release of the Altair SimSolid Standard and Power editions, safety factors contour plots can be displayed for … Read More

New Altair SimSolid hydrostatic pressure load

Hydrostatic pressure is defined as the pressure exerted by a fluid at equilibrium due to the force of gravity. Hydrostatic pressure increases in proportion to depth measured from the surface because of the increasing weight of fluid exerting downward force … Read More

New Altair SimSolid hydrostatic pressure load

Hydrostatic pressure is defined as the pressure exerted by a fluid at equilibrium due to the force of gravity. Hydrostatic pressure increases in proportion to depth measured from the surface because of the increasing weight of fluid exerting downward force … Read More

How Altair SimSolid processes units

In Altair SimSolid, all model geometry is stored in the units defined by the CAD system or, in the case of STL, the units defined when reading the file. For consistency, all measurements or other references to the geometry will … Read More